preparation12 min read

How to Store a Convertible Long Term

Store a convertible for a long sit: top up or down, vinyl or canvas, the rear window, seals, interior moisture, the cover, and a spring check.

How do I store a convertible long term?

Short answer

Store a convertible with the top fully up and latched when the top is healthy, the fabric and the rear window are dry, and the drains are clear. A top left down for months holds a crease. A plastic rear window folded against itself can haze. With the top down, the cabin takes whatever the room is doing. Vinyl and canvas fail in different ways. A plastic window and a glass window fail in different ways. Seals stick, drains clog, and a cover can press a crease into the window you were trying to protect.

Published Updated as of

Store a convertible with the top fully up and latched when the top is healthy, the fabric and the rear window are dry, and the drains are clear. A top left down for months holds a crease. A plastic rear window folded against itself can haze. With the top down, the cabin takes whatever the room is doing.

Vinyl and canvas fail in different ways. A plastic window and a glass window fail in different ways. Seals stick, drains clog, and a cover can press a crease into the window you were trying to protect. In the spring, cycle the mechanism while the car is still parked, before you need the top on the road.

Fuel, fluids, the battery, and the tires are the ordinary long sit. That work is how to store a classic car long term. This page is the top, the window, and the interior a folded roof leaves open. If the car will sit in your garage, the room is home garage storage for a classic.

Before a convertible stays put

  • Dry the top, the well, the drains, and the interior before the car stays.
  • Latch the top fully up unless the instructions for that top say to store it folded.
  • Clean vinyl or canvas the way that material allows, then let it dry.
  • Keep a plastic rear window out of a hard fold, and keep anything from pressing on it.
  • Clean the weatherstrips, wipe any dressing thin, and confirm the drains flow.
  • Use a breathable indoor cover that does not crease the rear window.
  • In spring, inspect the top, then cycle it once while the car is parked.

Top up or top down

A healthy top should spend a long sit fully up, latched at the header, with the side rails seated. That is the shape it holds on the road. The seals stay where they seal. The cabin is a closed space you can actually dry. A plastic window stays open instead of folded against itself. A top that is only laid on the windshield frame, unlatched, can shift, mark the paint, and leave a gap at the header.

Down is the weaker default. The fabric stays creased, the well collects leaves and water, and the seats and the carpet take the room's humidity with nothing above them. A plastic window in that fold can take a white crease that stays. Store the top down when the instructions for that top say to fold it, or when it will not latch and you are not going to force it. Halfway is the position to avoid. It is a gap for water, and it loads the frame and the pump in a posture they do not hold on the road. If a power top stalls between up and down, finish the travel or have it repaired before the long sit, with a battery strong enough to complete the move.

If the top must stay down, dry the well first, clear the drains, and put a soft clean cloth between a plastic window and the fold so the window does not press on itself or on a latch. A tonneau over a folded top keeps some debris off the cabin. It is not a roof, and it does not dry a wet well. Repair the top before you treat that setup as the storage plan.

Vinyl and canvas

Tell the two apart before you clean. Vinyl is a coated fabric. It feels smoother, and the damage that shows up later is cracking, stiffness, and a coating that clouds or peels. Canvas is a woven cloth. It holds water in the fibers, and the damage that shows up later is mildew, stains, and rot along the seams. A cleaner or a dressing suited to one can be a poor idea on the other. Follow the top maker's instructions when you have them.

For either material, brush loose dirt and leaves off before you add water. Wash with mild soap and water, rinse, and let the top dry completely before the car stays closed up. Skip solvents, bleach, and a scrub pad. They can dull a vinyl coating or drive dirt into canvas. If you use a protectant, use one the top's instructions allow for that material, and wipe off the excess. A heavy oily coat stays sticky, collects dust, and can transfer onto the rear window and the paint. Do the washing in weather that will actually dry the cloth. Putting a wet top up and shutting the garage does not finish the drying.

Look at the stitching and the binding where the window meets the fabric. Loose thread and a seam that has opened become a leak while the car sits, and you find it later as a stain in the lining. A small opening is easier to have repaired before storage than after a season of drip.

A plastic rear window or glass

A plastic rear window scratches when you wipe dry dust across it, and it hazes when a harsh cleaner sits on it. Wash it with plenty of water and a soft cloth. A dry paper towel is a poor tool here. If a cleaner does not say it is safe for plastic, keep it off the window. Ammonia cleaners are a common way these windows cloud. Dry by blotting. Small scratches are already in the plastic, and polishing them out is easy to do badly. If the window is badly hazed, a shop that works on convertible windows is a better next step than a rubbing compound from the shelf.

Store a plastic window open and supported. Top-up storage does that. A crease across the plastic can turn permanent and cloudy. If the top has to be down, the soft cloth in the fold is there so the window does not rest on a sharp crease or a metal latch. Keep the car cover, a box, and anything stored on a shelf off that window. Pressure plus time is how a clear panel becomes a white line.

Glass does not crease. Clean it gently, and do not scrape a defroster grid if the window has one. The seal around the glass still shrinks, cracks, and leaks, so treat that seal as part of the window. Leave zippers and cables where they belong. Do not twist the wiring of a heated window to force a fold the glass was never meant to make. If the glass is already loose in its seal, have it reseated before water follows the gap into the well.

Weatherstrips, seals, and drains

Seals fail in storage by sticking and by shrinking. Dry rubber left pressed to paint, or to the plastic window, can bond enough that the first opening tears the seal or lifts paint. Clean the weatherstrips with mild soap and water and let them dry. If the rubber is dried out, a protectant the car's instructions allow can help, wiped thin. Excess dressing stays wet, collects grit, and marks the paint. Shut the doors only after that film has dried, then open a door once before you leave so you know the seal releases.

Look for a seal that has pulled out of its channel. Press it back in if it is only unseated. If it needs adhesive, use one meant for automotive weatherstrip and keep it off the paint. If you are unsure, have a shop do it rather than glue a door shut. The header seal at the windshield and the seals at the side glass are the ones that show up stuck in the spring.

Drains are the other half. A convertible well, and often the cowl, has holes that should exit under the car. Leaves and a nest clog them. Then a modest leak fills the well and soaks the carpet from underneath. Find the holes, clear them by hand or with a soft wire, and pour a small amount of water. You want it to come out under the car, not into the cabin. Do this before storage and again in the spring. A dry well with clogged drains is a wet well after the first thaw.

Interior moisture and mildew

The lining of the top, the carpet, and the seat foam hold water. A car put away after rain, or with a leak at the header, will smell musty before you see a stain. Dry it first. Take wet floor mats out until they are dry. On a dry day, leave the doors open with the top up, and close the car once the cabin smells like cloth again. Leaving it open overnight brings in dew and gives pests a door.

A desiccant in a closed cabin takes up some of that trapped moisture until it is spent. Check it when you look at the rest of the car, and renew it the way its label says. It does little with the top down or the windows open, because a small container cannot dry the whole garage. Cracked windows are a weak moisture plan on a convertible. Humid air and pests come in, and the seals sit unloaded instead of in the latched position.

If the canvas already smells of mildew, wash it and dry it fully. Shutting the garage on a damp top keeps that moisture in the cloth. The car cover and moisture guide is how the cover and the room either let that moisture out or hold it against the car. The seats, the carpet, and the smell in the cabin are interior, leather, and mildew care.

Which cover to use

Indoors, use a clean breathable cover, and only after the top and the cabin are dry. The cover should not press a plastic rear window into a crease or drag a seam across the glass. If a seam lands on the window, shift the cover. A waterproof outdoor cover used inside, or a plastic tarp, holds moisture against the top and the paint. That is the failure the moisture guide describes.

Outdoors is a weak place for a convertible. If you have no indoor space, keep the top up, keep the drains clear, and use a fitted rain cover that will not flap the window raw. Look the car over more often than you would in a garage. A cover is not a dry room. A folded top in the weather is a well full of rain. Move the car inside when you can.

Spring check of the top mechanism

Before a road trip, read the cabin note and do the ordinary startup in the spring startup guide. Add the top to that morning while the car is still parked. Look at the fabric, the window, the seals, and the drains. Then cycle the top fully down and fully up once.

The battery needs to be up to that job. A weak battery and a power top can stall halfway, and halfway is a gap for water plus a load on the frame. Follow the car's instructions for whether the engine should be running. Watch both sides. One side leading can bend the frame. Release the switch if the top binds, if a cable or a strap has jumped, or if you see hydraulic fluid at a ram or along a hose on a hydraulic top. Holding the switch burns the motor and can tear the fabric. A manual top should latch without a fight. If the header will not meet the windshield, stop and find what is in the way.

After it latches, look again at a plastic window for a new crease and at the seals for a fresh tear. A slow hydraulic leak is a shop job before a highway trip. So is a window that has pulled out of the top, or a latch that closes on one side only. When the top works and the rest of the startup checks pass, make the first drive with the top up so you learn about a drip before a storm does.

Frequently asked questions

Should I store a convertible with the top up or down?

Up and latched, when the top is healthy. That keeps a plastic window out of a fold, keeps the cabin closed, and holds the seals in their working shape. Store it down when that top's instructions say so, or when it cannot latch and you have dried the well and protected the window. Leave it halfway up only long enough to fix the stall.

How should I care for a vinyl top versus a canvas top?

Wash either with mild soap and water, rinse, and dry it completely before the car stays put. Vinyl is a coating that cracks and dulls if you attack it with solvents or a scrub pad. Canvas holds water and mildews if it stays damp. Use a protectant only when it is meant for that material, and wipe off the excess.

How do I protect a plastic rear window in storage?

Wash it wet, with a soft cloth, and keep ammonia cleaners and dry wiping off it. Store the top up so the window is not folded. If the top must be down, put a soft cloth in the fold so the plastic does not crease against itself. Keep the car cover from pressing on the window.

What should I do with weatherstrips and drains?

Clean the seals, let them dry, and wipe any dressing thin so they do not stick to the paint. Clear the well and cowl drains and confirm water comes out under the car. A clogged drain fills the carpet from below after the first rain or thaw.

What should I check on the top mechanism in spring?

With a strong battery, cycle the top fully once while the car is parked. Stop if it binds, if a cable jumps, or if hydraulic fluid shows at a ram or a hose. Confirm both latches, look at the window and the seals, and follow the spring startup guide for the rest of the first drive.

Bottom line

A convertible stores best with a dry top fully up and latched, a rear window that is not creased or crushed, seals that will release, and drains that flow. Vinyl wants to stay clean and fully dry. Canvas wants to stay dry so it does not mildew. The cover should breathe, and it should not press on the window.

Cycle the mechanism in the spring before you need it, and stop when it binds. Fuel, the battery, and the tires still follow the long-term layup. The top is the extra system a closed roof does not have.

convertiblesoft toprear windowweatherstriplong-term storage

Related guides

All guides →